Low-Cost, Replaceable Belts for Die Cutting Systems

Belts for Ttarp die cutting presses are available in plastic, extra-hard paper, and poly-coated paper.

Download Product Sheet

• The cutting belt carries product into and out of the press, making notching unnecessary. Stretching and distortion of materials are eliminated. Cut pieces are easy to pick.

• Small sheets or pieces can be carried by the belt and positioned accurately under the die.

• The die cuts into the belt, not against the steel platen. This prevents damage to the knife edge. Die life is increased up to ten times or more.

• Since the cutting rule stays sharper, longer, better quality cuts are produced with less tonnage required.

• The clean cut produced by the belt allows feed-thru punches to be used within the die for automatic slug removal by an air clean-out process.

• Thru-cutting, kiss cutting and slug removal can all be done with the same die.

• Adjustable four-corner stop blocks control the depth of the cut, prolonging belt life.

• A make-ready sheet under the belt makes it easy to shim small areas or spots of the die to ensure a 100% clean cut.

• Make-ready sheets are stored with the die to save time setting up for the next run. Many dies will not require any set-up because of the cutting belt.

• Belts can be replaced easily in five minutes or less.

• Belts are low in cost and available in plastic, extra-hard paper, and poly-coated paper.

Click here to request pricing or additional information.