Ttarp Replaceable Belts for Die Cutting Offer These Performance Advantages:

• The cutting belt carries product into and out of the press, making notching unnecessary. Stretching and distortion of materials are eliminated. Cut pieces are easy to pick.
• Small sheets or pieces can be carried by the belt and positioned accurately under the die.
• The die cuts into the belt, not against the steel platen. This prevents damage to the knife edge. Die life is increased up to ten times or more.
• Since the cutting rule stays sharper, longer, better quality cuts are produced with less tonnage required.
• The clean cut produced by the belt allows feed-thru punches to be used within the die for automatic slug removal by an air clean-out process.
• Thru-cutting, kiss cutting and slug removal can all be done with the same die.
• Adjustable four-corner stop blocks control the depth of the cut, prolonging belt life.
• A make-ready sheet under the belt makes it easy to shim small areas or spots of the die to ensure a 100% clean cut.
• Make-ready sheets are stored with the die to save time setting up for the next run. Many dies will not require any set-up because of the cutting belt.
• Belts can be replaced easily in five minutes or less.
• Belts are low in cost and available in plastic, extra-hard paper, and poly-coated paper.

Ttarp automatic die cutting systems are widely used to cut non-metallic materials for gasket, foam, packaging, rubber, automotive, textile and other industries.